Load Defaults; Last Fault; Priming Speed And Duration - Jandy Pro Series JEP-R Manual De Instalación Y Operación

PAGE 14
ENGLISH
To set the minimum speed, from the service setup menu,
select using the arrow keys. Press
SET MIN LIMIT
. Using the arrow keys, set the minimum speed to
MENU
the desired value. Press
MENU
SET MIN LIMIT
2
MENU
To set the maximum speed, from the service setup
menu, select
SET MAX LIMIT
Press . Using the arrow keys, set the maximum
MENU
speed to the desired value. Press
store.
SET MAX LIMIT
2
4.3

Load Defaults

To restore factory default settings to the controller, from
the service setup menu, select
. Using the arrow keys, select
MENU
to restore factory default settings.
LOAD DEFAULTS
2
Default Speeds
eStar
Speed 2 - 8
Priming Speed
Other Defaults
Freeze Protect Duration
Priming Duration
JEP-R Variable-Speed Pump Controller
to accept and store.
RPM: 600
4
3
using the arrow keys.
to accept and
MENU
RPM: 3450
3 4
MENU
. Press
LOAD DEFAULTS
. Press
YES MENU
YES
3 4
MENU
1750 RPM
2750 RPM
2750 RPM
30 min
3 min
|
Installation Manual
4.4

Last Fault

This feature shows on the top display line, the most
recent unique fault message and on the bottom display
line, the second-to-last unique fault message. If there
is no entry for a fault, the display will show "*---------
-------*" on the corresponding line. To select last fault,
from the service setup menu select
.
MENU
NOTE The fault messages are stored in non-volatile
memory, and remain even with no power. To
clear the fault history, press either arrow key.
SELECT SERVICE SETUP
2
MENU
4.5

Priming Speed and Duration

The controller will command the variable-speed pump
to operate at the priming speed for the priming duration
specified (except during timer program overlaps or
follow-on commands where the pump is not stopped
before changing speeds). From the service setup menu,
select using the arrow keys. Press
PRIMING
PRIMING DURATION
2
To set priming speed, select
the arrow keys. Press
MENU
the priming speed to the desired value. Press
accept and store.
PRIMING SPEED
2
MENU
. Press
LAST FAULT
LAST FAULT
4
3
MENU
MIN: 3
4
3
MENU
using
PRIMING SPEED
. Using the arrow keys, set
MENU
RPM: 3450
3 4
.
to