Section 5. User Set Up Options; Setting Time-Of-Day; Labeling Speeds; General Labels - Jandy Pro Series JEP-R Manual De Instalación Y Operación

PAGE 16
ENGLISH
To disable the power display feature, from the service
setup menu select
DISPLAY POWER USAGE
to select. Using the arrow keys, select
MENU
to accept and store.
MENU

Section 5. User Set Up Options

NOTE The controller must be in the OFF mode before
entering the user setup mode. While in setup
mode the controller will return back to the OFF
mode after one (1) minute since the last key
press.
When in setup mode, speed keys "
used as 'escape' or exit keys while navigating the setup
menu.
To enter the setup mode, press and hold the
button for five (5) seconds. The controller displays
SELECT USER SETUP.
the desired setup item to change.
5.1

Setting Time-of-Day

From the Setup menu, select
button to display the currently-set time. Using
MENU
the arrow keys, adjust to the desired time. Press
to save your setting.
5.2

Labeling Speeds

The controller comes from the factory with pre-
programmed labels or names for the preset speeds. The
labels may be changed as desired to suit your particular
installation.
Two (2) types of labels are provided by the controller:
• General Labels - selected from a list
• Custom Labels - created by the user
From the setup menu, scroll to
. The SELECT SPEED screen
and press MENU
is displayed. Press the
MENU
JEP-R Variable-Speed Pump Controller
. Press
. Press
NO

" through "4" are
MENU
Using the arrow keys, select
. Press the
SET TIME
MENU
LABEL SPEED
button to display the
|
Installation Manual
currently selected speed. Using the arrow keys, choose
the speed to be changed. Press
controller displays
SELECT LABEL TYPE
or
GENERAL CUSTOM
SELECT USER SETUP
LABEL SPEED
5.3

General Labels

Using the arrow keys, select a general label from the list
to assign to the speed. Press
the speed.
LABEL SPEED
FILTRATION
5.4

Custom Labels

In the custom label mode, the controller displays a
flashing cursor at the character position to be changed.
Using the arrow keys, change the character as desired.
Press to accept the change and advance to the
MENU
next character position. Press any speed key "
through "4" to return to the previous cursor position.
LABEL SPEED
1:PRESET 1
Continue this procedure until the end of the label is
reached. The new label is saved when
at the last character position.
5.5

Display Light Control

The controller's display is equipped with a backlight to
aid viewing in low light conditions.
to select. The
MENU
. Select
as desired using the arrow keys.
to assign the label to
MENU

"
is pressed
MENU