Estar Speed; Pump Freeze Protect Operation; Selecting Pump Type; Display Power Usage - Jandy Pro Series JEP-R Manual De Instalación Y Operación

To set priming duration, select
using the arrow keys. Press
keys, set the priming speed to the desired value in
minutes from one (1) to five (5) minutes. Press
accept and store.
PRIMING DURATION
2
MENU
4.6

eStar Speed


The " " speed is intended to be used as an energy-
efficient setting that can be easily called-up by
activating the eStar preset speed from the keypad or
remote closure. After this speed has been determined
by the installer, the eStar speed may be set as follows:
From the service setup menu, select
. Press . Using the arrow keys, set the
SPEED MENU
speed to the desired value. Press
store.
2
4.7

Pump Freeze Protect Operation

When enabled to do so, the controller monitors the
temperature inside the pump and will activate the
variable-speed pump at the eStar speed when the
temperature approaches freezing. The run duration of
the pump freeze protect operation is adjustable from 30
minutes to 8 hours, or may be disabled completely.
To set the pump freeze protect operation, from the
service setup menu select
Press . Using the arrow keys, set the duration to
MENU
the desired value. To disable pump freeze protect, set the
duration to 0:00. Press
MENU
PUMP FREEZE PROTECT
2
MENU
JEP-R Variable-Speed Pump Controller
PRIMING DURATION
. Using the arrow
MENU
MENU
MIN: 3
3 4
SET ESTAR
to accept and
MENU
1:eSTAR
RPM:1250
3 4
MENU
PUMP FREEZE PROTECT
to accept and store.
1:05
3 4
|
Installation Manual
to
Freeze protection is intended to protect equipment and
plumbing for short periods of freezing only. It does this
by activating the filtration pump and circulating the water
to prevent freeze inside equipment or plumbing. Freeze
protection does not guarantee that equipment will not be
damaged by extended periods of freezing temperatures
or power outages. In these conditions, the pool and spa
should be shut down completely (e.g. drained of water
and closed for the winter) until warmer weather exists.
The pump freeze protect run time may be interrupted by
pressing a speed key, as follows:
Pressing the key "
protect run time, pressing it twice turns off the pump.
Pressing other speed keys will override the pump freeze
protect run time and activate the selected preset speed.
4.8

Selecting Pump Type

The controller may be used to operate various types of
pumps. It is important to select the correct pump type at
this menu item to ensure proper controller operation.
From the setup menu, select
button to display the currently selected pump
MENU
type. Using the arrow keys, choose the pump type that
matches the type of the installed pump. Refer to the
pump manual for information regarding the pump type.
.
4.9

Display Power Usage

The controller can alternately display the variable-speed
pump power usage while the pump is in operation and
the controller is in Run Mode.
To enable the power display feature, from the service
setup menu select
to select. Using the arrow keys, select
MENU
to accept and store.
MENU
ENGLISH
WARNING

" once overrides the pump freeze
. Press the
PUMP TYPE
DISPLAY POWER USAGE
PAGE 15
. Press
. Press
YES