1. With the cuff wrapped around your wrist, press the "START/
STOP" button. Do not inflate the cuff unless it is wrapped around
your wrist. All digits will light up to check the display functions. The
checking procedure will be completed after about 3 seconds.
2. After all symbols disappear, the display will show "0". The
monitor is ready to measure and will automatically inflate the
cuff to start measurement.
3. When the measurement is completed, the cuff will deflate
entirely. Systolic pressure, diastolic pressure, and pulse will be
shown simultaneously on the LCD screen. The measurement is
then automatically stored into memory.
NOTE:
• This monitor automatically turns off approximately 1 minute after
last operation. You may also press the "START/STOP" button
to turn the unit off.
• To interrupt the measurement, you may press the "START/
STOP" (recommended) or "MEM" buttons. The cuff will
deflate immediately after this button is pressed.
17