Drive Roll And Wire Guides Table; Flux-Cored Weld - Lincoln Electric POWER MIG 180 DUAL Manual De Operación

POWER MIG 180 DUAL
®
Wire Diameter & Type
.025"(0.6mm) MIG wire .025"/.030" (0.6mm/0.8mm)
.030"(0.8mm) MIG wire
.035"(0.9mm) MIG wire .035"(0.9mm) Smooth Drive Roll
.030"(0.8mm) flux-cored .030"/.045" (0.8mm/1.1mm)
.035"(0.9mm) flux-cored
.045"(1.1mm) flux-cored .030"/.045" (0.8mm/1.1mm) Knurled
(See Figure B.6 for the following Items.)
13. CIRCUIT BREAKER – If the rated input current of the
machine is exceeded this circuit breaker will trip. Press to
reset.
14. GAS INLET – Shielding gas connects to this inlet.
15. POWER CORD CONNECTION - Ensure power cord is dicon-
nected from input voltage supply prior to connecting or
removing the cord from the machine. Connect the circular
connector present on either input cord (120V or 230V) to the
receptacle on the back of the machine. The power cord con-
nector is secured to the receptacle by rotating the connec-
tor's coupling ring clockwise, until the coupling ring latches
on to the receptacle. Use only the appropriate (120V or 230V)
power cords supplied by the Lincoln Electric Company.
A. ITEMS NEEDED FOR FLUX
CORED WELDING
1. 035"(0.9mm) Contact Tip
2. .025"-.035"(0.6mm-0.9mm) wire guide
INNER WIRE GUIDE
.025-.035 (.6-.9mm)
TABLE B.1
DRIVE ROLL AND WIRE GUIDES
Drive Roll
Smooth Drive Roll
Knurled Drive Roll
Drive Roll
SETTING UP AND MAKING A FLUX-CORED WELD
3. Knurled Drive Roll
4. .035"(0.9mm) NR-211MP Flux-Cored
Wire
Drive Roll Part Inner Wire Guide
Number
KP2529-1
.025"-.035" (0.6mm-
KP2529-2 0.9mm) Steel Wire
Guide
KP2529-3
.045"(1.1mm) Steel
KP2529-3
Wire Guide
FIGURE B.6
14
13
5. Black Flux Cored gun nozzle
6. Welding Gun
7. Work Cable & Clamp
B 4
OPERATION
Inner Wire Guide Part
Number
KP2531-1
KP2531-2
15