ims PRO PULSEMIG 220 C Manual Del Usuario página 42

TRACEABILITY
This welding management interface allows you to trace/record all the steps of the welding operation, bead by bead, during industrial manufactu-
ring.
This qualitative approach ensures a post-production welding quality that allows the analysis, evaluation, reporting and documentation of the
recorded welding parameters. This feature complies with EN 3834.
This mode allows the recording of weld seams and the recovery of this data via an export to a USB stick. These data will be processed in.CSV
format.
When «Start» is started in this mode, a working session is created and all welding will be recorded under it, named and time-stamped.
The «Explore» function allows you to access the list of created work sessions, sort them and also delete them. The pictogram shows the details of
each session with the following information: sampling frequency, number of beads recorded, total welding time, welding energy supplied, configura-
tion of each bead (process, time stamp, welding time and welding U-I).
The recovery of this information is done by exporting the data to a USB key.
ENERGY MODE
This mode developed for welding with energy control framed by a DMOS allows, in addition to the energy display of the bead after welding, to set:
- The thermal coefficient according to the standard used: 1 for ASME standards and 0.6 (TIG) or 0.8 (MMA) for European standards. The displayed
energy is calculated by taking this coefficient into account.
- The length of the weld seam (OFF - mm): if a length is recorded, then the energy display is no longer in joule, but in joule / mm (the unit on the
display «J» flashes).
WELDING CYCLES
Standard 2T process:
Dstart
Soft-start
When the trigger is pulled, the Pre-gas starts. When the wire comes into contact with the metal, a pulse ignites the arc and the welding cycle starts.
When the trigger is released, the feeding stops and a current pulse cuts the wire properly followed by the Post gas. While the Post gas is still going,
pulling the trigger allows to quickly restart the weld (manual chain point) without going through the HotStart phase. A HotStart and/or Crater filler
can be added to the cycle.
42
PULSEMIG 220 C / 220 C XL
T hotstart
I
T crater Filler
EN
I blackout
Gas post-Flow
T burn-back
I crater Filler