Setting The Reheating Function Timer Programme; Setting The Circulation Pump Timer - Vaillant auroMATIC 560 Instrucciones De Uso Y De Instalacion

Display Required steps
Turn the dial - after 3 seconds the cursor
marks the temperature display, which
also flashes.
Set the target value for the cylinder tem-
perature by turning the dial.
Click the dial - the cursor marks the op-
erating modes. The mode that has been
set flashes.
Select an operating mode by turning the
dial.
Click the dial - the cursor marks the day
of the week. The day of the week that
has been set flashes.
Set the current day of the week by turn-
ing the dial.
Click the dial - the cursor marks
the hours and minutes display.
Set the current time of day by turning
the dial.
Table 5.2 Settings in the main operating level
5.5.3 Setting the reheating function timer pro-
gramme
You can create a timer programme with up to three time
windows for reheating the solar cylinder.
The controller is provided with a basic programme which
you can adapt to your own requirements.
Time window Current day/
Block of days
H 1 MO - SO
H 2 —
H 3 —
Table 5.3 Basic programme for reheating
Setting the desired times is carried out in four steps:
1. Select the time window
2. Select the weekday or block of days
3. Set the start time
4. Set the end time
You can specify up to three time windows, provided that
the times in the three windows do not overlap.
For clarification, the individual steps are shown again in
the following table:
Operating Manual auroMATIC 560 0020060907_00
Start time End time
5:30 22:00
— —
— —
Display Required steps
Press the programming button P.
Turn the dial until the tap symbol ap-
pears.
Click the dial and the cursor marks the
changeable value (H1), which additionally
flashes.
Select the desired time window by turn-
ing the dial.
Settings: H 1, H 2, H 3
Click the dial – The cursor marks the
block of days display, which also flashes.
Select a block of days or a day of the
week by turning the dial.
Settings: (MO-SU); (MO - FR); (SA-SU);
(MO); (TU); (WE); (TH); (FR); (SA); (SU)
Click the dial – The cursor marks the
start time and the hours display flashes.
Select the start time by turning the dial.
Click the dial again to set the minutes.
Click the dial – The cursor marks the end
time and the hours display flashes.
Select the end time by turning the dial.
Click the dial again to set the minutes.
Table 5.4 Setting time windows
5.5.4 Setting the circulation pump timer pro-
gramme
As with the reheating function, a customised timer pro-
gramme can be entered for a circulation pump, if con-
nected (only possible with hydraulic plan 1).
The controller is also equipped with a basic program in
this case:
Time window Current day/
Block of days
H 1 MO - SO
H 2 —
H 3 —
Table 5.5 Basic programme for the circulation pump
Operation 5
Start time End time
6:00 22:00
— —
— —
GB
11