Makita LS1016 Manual De Instrucciones página 25

In the case of right bevel cut
Table (A)
Molding position
For inside corner
For outside corner
006363
Table (B)
Molding position
For inside corner
For outside corner
006364
Example:
In the case of cutting 52/38° type crown molding for position (1) in Fig. 54 & 55:
• Tilt and secure bevel angle setting to 33.9° RIGHT.
• Adjust and secure miter angle setting to 31.6° RIGHT.
• Lay crown molding with its broad back (hidden) surface down on the turn base with its WALL CONTACT EDGE
against the guide fence on the saw.
• The finished piece to be used will always be on the RIGHT side of the blade after the cut has been made.
Crown molding stoppers (optional accessories) allow easier cuts of crown molding without tilting the saw blade. Install
them on the base as shown in the figures. (Fig. 56 & 57)
Fig. 56: At right 45° miter angle
Fig. 57: At left 45° miter angle
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT EDGE
against the crown molding stoppers as shown in the figure (Fig. 58). Adjust the crown molding stoppers according to
the size of the crown molding. Tighten the screws to secure the crown molding stoppers. Refer to the table (C) for the
miter angle.
Table (C)
Molding position
For inside corner
For outside corner
006365
7. Cutting aluminum extrusion
When securing aluminum extrusions, use spacer blocks
or pieces of scrap as shown in Fig. 59 to prevent defor-
mation of the aluminum. Use a cutting lubricant when
cutting the aluminum extrusion to prevent build-up of the
aluminum material on the blade.
in Fig. 54 & 55
52/38° type
(1)
(2)
Right 33.9°
(3)
(4)
Molding edge against guide fence
in Fig. 54 & 55
Wall contact edge should be against
(1)
guide fence.
(2)
Ceiling contact edge should be
against guide fence.
(3)
Wall contact edge should be against
(4)
guide fence.
Miter angle
in Fig. 54 & 55
(1) Right 45°
(2)
(3)
(4) Right 45°
Bevel angle
45° type
Right 30°
Save the right side of blade
Save the left side of blade
Left 45°
Save the right side of blade
Save the left side of blade
WARNING:
• Never attempt to cut thick or round aluminum
extrusions. Thick or round aluminum extrusions can
be difficult to secure and may work loose during the
cutting operation which may result in loss of control and
serious personal injury.
Miter angle
52/38° type 45° type
Right 31.6° Right 35.3°
Left 31.6° Left 35.3°
Right 31.6° Right 35.3°
Finished piece
Finished piece will be on the Right
side of blade.
Finished piece will be on the Left
side of blade.
Finished piece
25