Technical Data - PiC indolor MissAPPY Instrucciones De Uso

GB
pressor. Proper maintenance of the fi lter
prolongs the life of the aerosol unit. Filter
replacement times depend on the exter-
nal conditions of use of the device. We
recommend replacing fi lters after around
20 hours of use or if they are visibly dirty.
The fi lter is on the front of the aerosol
unit (c)
To replace the fi lter :
• Open the fi lter cover
• Remove the fi lter from its housing
• Carefully fi t the new fi lter
• Re-fi t the fi lter cover

TECHNICAL DATA

Nominal voltage 230 V
Frequency 50Hz
Power: 140VA
Fuse: T 1,6A 250~
Maximum fl ow rate : 14 l/min
Operating fl ow : 7 l/min
Maximum pressure : 3 atm
Working pressure : 0.6 atm
Protection against liquid seepage : IPX0
Weight: 2Kg
Conditions for using the device: 20 ON
– 40 OFF
MMAD: 2,63 µm
% of particles below 5µ /
Breathable part: 77%
Nebulizer cup capacity : 5 ml
Noise level at 50 cm* : 65 dB
*Data on noise levels were measured on
a new device. Values may vary with use.
The information on performance provided
by the manufacturer in accordance with
standard EN 13544-1 may not be applica-
ble to medicines sold as suspensions or
with viscosity.
EN 60601-1 Medical electrical equipment
– Part 1 : general requirements for sa-
fety
EN 60601-1-2 Medical electrical equip-
ment – Part 1 : general requirements for
safety – Collateral standard : electroma-
gnetic compatibility – Requirements and
tests
EN 13544-1 Respiratory therapy equip-
ment – Part one: Nebulizing systems and
their components
LEGEND OF
SYMBOLS:
Caution! Read instructions
Type B device
Double insulation
Complies with directive
MDD 93/42/EEC
Alternate current
Conditions for storage :
Relative humidity: 15% / 85%
Temperatures: -10°C / +55°C
"The medical device requires special pre-
cautions regarding electromagnetic com-
patibility and shall be installed and put
into service according to the information
provided in the user manual"
14