Incorporating A Sampled Sound Into A Drum Set (Drum Sampling) - Casio CTK-4200 Guia Del Usuario

CTK4200_WK220_e.book 22 ページ ２０１１年４月１５日 金曜日 午前１０時１分
Sampling Sounds and Playing Them on the Digital Keyboard
Applying Effects to a Sampled Sound
You can apply various effects to sampled sounds.
1. bn
Press (TONE) and then use
enter the tone number (601 to 605) to which you
want to apply effects.
bn
2.
Press (TONE) to cycle through the available
effects, described below.
Effect Type
(Display)
Normal sampled tone (no looping, no
Original (Orgnl)
effect).
Loop 1 (Loop1) Loops the sampled sound.
Loops the sample sound and raises the
Loop 2 (Loop2) pitch of the resonating sound when the
keyboard key is released.
Loops the sample sound and lowers the
Loop 3 (Loop3) pitch of the resonating sound when the
keyboard key is released.
Changes the pitch from low to high, at an
Pitch 1 (Ptch1)
increasing rate.
Changes the pitch from high to low, at a
Pitch 2 (Ptch2)
decreasing rate.
Changes the pitch from high to low, at a
Pitch 3 (Ptch3) decreasing rate, and then raises the pitch
when the key is released.
Tremolo (Treml) Alternates volume between high and low.
Adds vibrato and changes the pitch by a
Funny 1 (Funy1)
gradually increasing amount.
Alternates between high pitch and low
Funny 2 (Funy2)
pitch.
Adds vibrato and changes the pitch from
Funny 3 (Funy3)
low to high.
• Avoid assigning the same sampled sound to the keyboard
for play along and for looped play. Doing so will cause, the
Loop 1 effect to be applied to the keyboard tone while
looped play of the sampled sound is being performed.
E-22
br
(10-key) to
Description
Incorporating a Sampled Sound
into a Drum Set (Drum Sampling)
You can use the procedure to change the drum sounds that
are assigned to each keyboard key.
• You can store up to three drum sets and store them as tone
numbers 606, 607, and 608. Simply select the tone number
where the drum set you want is located to assign the drum
set sounds to the keyboard.
1. bo
Press (RHYTHM).
2. bn
Press (TONE) and then use
enter the tone number (606, 607, or 608) for the
drum set whose sounds you want to change.
N o D a t a
Lights
3. cr cs
Press and at the same time.
N o D a t a
Flashes
br
(10-key) to