diversey TASKI swingo 4000 Manual De Instrucciones página 70

Moving the machine (in the case of a defect)
Notice:
Generally, the machine should only be moved in
pairs.
Warning:
Due to the high weight, manual movement of the
machine is risky!
Missteps can lead to personal injury and damage to the
machine.
• Movement is only possible when the release button is
pressed. (See page 64)
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
Caution:
Before using the machine, check the pad drive
holder for wear and defects.
Any pad drive holder that is not intact or defective may
spin off the machine while working. In the case of non-
adherence there is a risk of accidents.
• Position the tools under the brush unit.
• Press the Brush drive ON/OFF but-
ton.
The brush unit will be lowered auto-
matically; the tools will be engaged
and stopped.
Caution:
Check whether the brushes are engaged.
Notice:
The brush drive is activated by pressing the gas
pedal.
Squeegee assembly
• The machine must be switched off.
• Position the squeegee (2) below the
squeegee holder (1).
1
2
68
• Push the squeegee holder down-
wards to latch onto the squeegee.
• Firmly attach both suction hoses to the sockets of the
squeegee.
Filling the fresh water tank
Caution:
Max. permissible water temperature 60 °C/140 °F.
- Diversey recommends using cold water, as hot water
will adjust to the ground temperature as soon as it
comes into contact with the ground. Thus there are no
advantages to using hot water.
• The machine must be switched off.
• Open the tank lid.
• Put the fresh water tank (Flextank) onto the provided fix-
ture.
• Take the dosing cup from the fresh water tank (Flextank).
• Fill water into the fresh water tank
(Flextank).
The upper red marking indicates the
max. permissible filling level.
• Tilt the tank cover back to the original position.
Dosing
Warning:
Wear gloves, goggles and appropriate (protective)
working clothes when handling chemical products!
Danger:
Use chemical products recommended by Diversey
only and always observe the product information.
Using unsuitable products (e.g. products containing
chlorine, acids or solvents) may cause harm to health
and severe damage to the machine.
Dosing examples:
Information on the package of
the product
0.5% 50ml for 10l of
water
1% 100 ml for 10l
of water
2% 200 ml for 10l
of water
3% 300 ml for 10l
of water
• Fill the dosing cup with a suitable product and pour the con-
tent into the fresh water tank. Repeat the procedure until
the required dosing is reached.
• When dosing is finished, the dosing cup will remain in the
tank.
Tank capacity Product vol-
ume per tank
filling
200l 1l
200l 2l
200l 4l
200l 6l