General Safety Regulations; Limits To Use; Cleaning Agents; Limiting Values - Wetrok iMatic XR85 Instrucciones De Manejo Abreviadas

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 43
Further dangers:
Injury or burns may result from battery terminals being shorted by hand or by conductive objects.
Do not get fingers caught in edge at hinge of tank lid, danger of crushing!
The built-in laser is switched off automatically by delay when machine is idle. To prevent damage to eyes, do not look at laser ray when it
is switched on!
2.4 Using for the first time / Use
Delivery, instruction on safety regulations, handling and service, in addition to initial commissioning is normally undertaken by a Wetrok
approved specialist. If this is not the case, the operator is responsible for instructing the operator.
Safe working with the appliance is only possible if you have completely read and understood the operating and safety instructions, and if
you adhere strictly to the directions contained therein.
Safety instructions for operation and servicing are set out in the respective chapters, and must be observed without fail!
Note also the safety instructions of the pictograms on the machine.
Check all electric cables.
Faulty lines may be replaced only by specialists.
All panels and covers must be in their correct positions before commissioning.

2.5 General safety regulations

Check machine before using every time.
Repairs may be carried out only by specialists.
Only one person may operate the machine at any one time.
Do not operate machine without fluid.
Before starting work, remove jewellery such as rings and necklaces.
Before starting work, tie back any long hair.
Wear sturdy footwear to prevent injury, as machine can weigh as much as 755 kg (approx. 1664 lbs)!
Before use, close and bolt the tank housing and the tank lid.
Note the presence of other persons nearby, especially children.
To clean and service the machine, change parts or dismantle parts: move machine onto an even surface without dips, and remove key
from key switch.
Use only original Wetrok parts.
Take care when turning on inclines or declines: proceed slowly and with care! When pushing machine over ramps, move only in the
direction of the ramp, never at an angle to it!
On slopes or in lifts, secure machine against inadvertent travel. Press emergency stop button. Remove key from key switch.
There are warning symbols for crushing hazard on the rear to the left and right of the recovery water tank. The recovery water tank must
only be tilted backward, if it is empty. Be careful when tilting the recovery water tank forward: Do not place fingers in closing edge, danger
of injury!
Take care when reversing machine. When releasing the throttle grip, the machine stops, press the emergency stop button in case of an
emergency.
Always isolate cable connection between battery and machine before doing any work on electrical installations.
After finishing work, empty tank containing dirty water in the interests of hygiene.

2.6 Limits to use

2.6.1 General
Do not use machine at temperatures below 1°C and above 45°C.
Water temperature must not exceed 50°C.
In the interests of safety, always adapt speed to user (floor condition, environment, contamination, etc)!
Suction or disposal of hazardous dust and inflammable material is prohibited.
Cleaning floors near highly inflammable or explosive substances is prohibited.
If battery voltage drops below 17 V, machine is switched off automatically and is stationary. There is an advance warning (continuous tone).
Using the machine in environments where chlorine is present, such as swimming pools, will reduce the service life of the machine
considerably, and is not recommended.
After sudden change from a cold to a warm environment, allow machine to acclimatise before use. Thawing can result in faulty operation,
and should be avoided.

2.6.2 Cleaning agents

To achieve optimum cleaning and service life of the machine we recommend using Wetrok chemical products. No guarantee or liability
will be accepted for damage or consequential damage resulting from the use of other products.
When using cleaning and care agents, note hazard warnings by manufacturer; wear protective goggles, gloves and clothing if necessary.
The use of foaming, highly inflammable, combustible, health-threatening, corrosive or irritant substances is prohibited.
Use only water and cleaning agents suitable for the machine.
Do not use any aggressive or inflammable cleaning agents for cleaning the machine!

2.6.3 Limiting values

Do not exceed gradients of 2% for work and 8% for transport or when machine is stationary. After having finished cleaning, the machine must
be secured against rolling away by turning the machine off and removing the key from the key switch.
DO NOT move the machine on slopes of more than 8%.
DO NOT reverse the machine down slopes of more than 8%.
DO NOT turn or drive the machine across slopes of more than 2%.
31
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido