Access Doors - Briggs & Stratton 040213 Manual De Instalación Y Arranque Rápido

Figure 3 — Location of Lifting Holes
To lift: Insert
pipe here
You may also lift the unit using a "hook and hoist" method
attached to the lifting pipes, provided that you use a
spreader bar to ensure that the chains or cables do not
touch the generator's roof.
After unit is in place, fill the lifting holes with the supplied
lifting hole plugs.

Access Doors

The Home Generator System is equipped with an
enclosure that has three access doors (Figure 4).The doors
are named for a significant component located behind
Figure 4 — Enclosure Access Doors
INSTALLATION
Installer-supplied pipe
Fuel Inlet
them. Starting with the side that has the fuel connection
and proceeding clockwise, the doors are named:
• Oil Fill door
• Control Panel door
• Oil Drain door
Each Home Generator System is equipped with two identical
keys.These keys fit the locks that secure the access doors.
WARNING
Running engines produce heat.Temperature of
exhaust port and nearby areas can reach or
exceed 600°F (316°C).
Severe burns can occur on contact.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
To Open an Access Door:
1. Insert key into lock of access door you wish to open
and turn one quarter turn counterclockwise.
2. Grasp door's handle and turn one quarter turn
counterclockwise to open. Remove key.
To Close an Access Door:
1. Close door and turn doors handle one quarter of a
turn clockwise.
2. Insert key into lock of access door and turn one
quarter turn clockwise. Remove key.
6
Exhaust
Port