I Starti Ng And Stopping A Cleaning Cycle - Zodiac RV 5480 iQ Manual De Instalación Y De Uso

3.6 I Starti ng and stopping a cleaning cycle

To prevent risk of injury or property damage, be sure to adhere to the following:
• Bathing is prohibited while the device is in the pool.
• Do not use the device during a shock chlorinati on. Wait unti l the chlorine level has reached
the recommended value before immersing the cleaner.
• Do not leave the device unatt ended for an extended period.
• Do not use the device if the rolling cover is closed.
• When there is power to the control unit, the following symbols light up to indicate:
- The acti on in progress
- The cleaning selected
- Maintenance required
• The control unit switches to standby aft er 10 minutes, and the screen switches off . Simply press a butt on to come out
of standby. Standby mode does not stop the device operati ng if it is in a cleaning cycle.
3.6.1 Choice of cleaning mode
• By default, a pre-confi gured cleaning mode "Bott om + sides + water line"; the symbols are illuminated and the
cleaning ti me is displayed on the screen.
• The cleaning cycle can be modifi ed before the device starts or while it is operati ng. The new mode will be started
immediately and the remaining ti me from the previous cycle will be zeroed.
Bott om only:
Bott om + sides + water line:
Water line only:
• Press
The cleaner adapts its movement strategy to the cleaning mode, in order to opti mise its rate of coverage.
Tip: to improve cleaning performance
At the start of the bathing season, run a few cleaning cycles in bott om only mode (aft er removing any large
debris with a net).
Regular use of the cleaner (not more than 3 ti mes a week) will keep your pool permanently clean and the
fi lter less clogged.
10