Proxxon FBS 240/E Manual De Instrucciones página 7

Operating instructions
Clamping and changing the bit
Important!
Unplug machine before changing bit.
Never press lock button 1 (Fig. 2) with machine running.
1. Slightly turn drill chuck 2 (Fig. 2) and simultaneously
press lock button (1) until the latter engages.
2. Open chuck and change bit.
When clamping drill bits, insert to minimise projecting
length. Long shafts bend easily and degrade true run.
We recommend PROXXON collet chucks for optimal true
running.
Using the machine
Important!
Always wear protective goggles when using the
machine.
Never use damaged grinding wheels or bent shafts.
1. Switch on machine at switch 4 (Fig. 1) and set the
appropriate operating speed at button 1 (Fig. 1).
Optimum grinding results are achieved through uniform
speed and not by applying excessive pressure.
Small cutters/bits = high speed,
Large cutters/bits = low speed.
2. When cutting or engraving, hold the machine as if it
were a pen (Fig. 3), being careful not to occlude the
vent slits.
3. For roughing down, grip the machine as if it were a
hammer (Fig. 4).
Note:
Disposal
Please do not dispose of the device in domestic wa-
ste! The device contains valuable substances that can
be recycled. If you have any questions about this,
please contact your local waste management enter-
prise or other corresponding municipal facilities.
Care and maintenance
When finished using the machine, unplug it and remove
any dust cling ing to vent slits.
EC declaration of conformity
We assume sole liability in declaring that this product
conforms with the following EC guidelines:
• EG-EMV Guideline 2004/108/EC
DIN EN 55014-1/09.2003
DIN EN 55014-2/02.2002
DIN EN 61000-3-2/10.2006
DIN EN 61000-3-3/06.2006
DIN EN 61000-3-2A2/09.2005
• EG-Low-Voltage Guideline 2006/95/EC
DIN EN 60745-1/12.2003
• EG-Machine Guideline 2006/42/EC
DIN EN 60745-1/12.2003
Date: 05.03.2009
Jörg Wagner
PROXXON S.A.
Equipment Safety Division
- 7 -