Technical Data; (Gb) Operating Instructions - Vivanco HDX 4.1 Instrucciones De Uso

Remote Control

(GB) Operating Instructions

The HDX 4.1 auto 1.3 HDMI Switching Unit allows multiple HDMI device access ,
such as DVD players, recorders, HD games consoles and satellite, cable tuner and
other set-top boxes to one HDMI (HD ready) display (LCD/Plasma TV, Beamer).
Safety precautions:
Please ensure sufficient ventilation. Ensure that ventilation is not impeded by
covering the ventilation openings at the bottom with items, such as newspapers,
table-cloths, curtains, etc..
Please don´t use apparatus at higher temperatures than: 50° C.
Please don´t expose apparatus to dripping or splashing and don´t place objects
filled with liquids, such as vases, onto the apparatus.
Please take attention to the environmental aspects of battery disposal: use your
national battery recycling system.
Lithium Battery: Caution: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's instructions.
Don´t use unit outdoors
In the event of malfunction, have the device repaired by a specialist.
Installation and Operation
1. Switch off all HDMI source devices and the HDMI display device (TV). Use
standard HDMI leads in order to connect HDMI outputs of your audio video
sources to the switching unit´s HDMI inputs and the unit´s HDMI OUTPUT to
the displays HDMI input. See fig. Connections.
Vivanco GmbH, Ewige Weide 15, D-22926 Ahrensburg, hotline@vivanco.de

Technical data

Technical Data
Inputs: 4 x HDMI Output: 1 x HDMI
Single Link Range: 480i / 480p / 720i / 720p / 1080i / 1080p
HDMI 1.3 compliant, HDCP copy protection
Bandwidth: up to 10,2 Gbps/400 MHz
HDMI sockets: gold plated
Power: powerd by HDMI source
2. Turn on the TV display.
3. Turn on the audio video sources
Press the Power On/Off Button , see fig. Front Panel Operation, for switching
4.
unit on or off.
5. Remote control battery insertion: Open the battery compartment on the
underside of the controller, see fig.. Then insert lithium battery type CR 2025.
Make sure that the polarity is correct: the "+" and "-" markings on the battery
and in the compartment must match. To check functionality, press Power
ON/Button on Remote Control, while directing the remote control towards the
Infrared Eye of the switching unit, see fig Front Panel Operation. If everything
is correct the Power Led on switching unit will light up.
6. External Infrared Eye: For remote control operation the whole switching unit can
be mounted in a hidden place. Just the External Infrared Eye must be
mounted visible e.g. on the TV set. Please plug-in the cable plug of the eye into
the External Infrared Eye socket at the rear side, see Fig. Rear Connections.
7. Manual Mode: To select manual mode press any CHANNEL Selection Button
on the remote control or on the front panel of the HDMI switching unit.
8. Automatic Mode: The unit will automatically detect and select the most recent
input source.
Frequently asked Questions
Switch box will not operate:
•
power LED is on.
No picture/signal or poor picture:
•
compliant. 2. Ensure HDMI leads lentghts: max 1,8 m or use of EQ leads. 3.
2
Make sure that a powered HDMI source and
1. Make sure that video display is HDCP