Publicidad
Idiomas disponibles
Idiomas disponibles
PW30AOV Owner's Manual
HOW TO STOP YOUR PRESSURE WASHER
1. Release spray gun trigger and let engine idle for two minutes.
2. Move throttle control lever on engine to SLOW position, then STOP (0)
position.
3. Move fuel shut-off valve to OFF (0) position.
4. ALWAYS point spray gun in a safe direction, press red button and
squeeze spray gun trigger to release retained high water pressure.
HOW TO STORE ACCESSORIES
The unit is equipped with multiple places to store your spray gun, nozzle
extension, and high pressure hose and spray tips.
1. Place spray gun into spray gun holder wireform as shown. (See Fig. 12)
2. Place nozzle extension into metal spring clips on side of unit as shown.
3. Coil high pressure hose onto hook on back of handle.
4. Insert multi–colored spray tips in spaces provided on handle.
HOW TO USE SPRAY TIPS (See Fig. 13)
The quick–connect on the nozzle extension allows you to switch between five different quick connect spray tips. Spray tips can
be changed while pressure washer is running once spray gun trigger is locked. The spray tips vary the spray pattern as shown.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current spray tip off. Store spray tips in holder provided on the handle.
2. Select desired spray tip:
• For delicate rinse, for gentle cleaning of cars/trucks, boats, RV's, patio furniture, lawn equipment, etc., select white 40°
or green 25° spray tip.
• For general rinsing, ideal for most all-purpose cleaning such as home siding, brick patios, wood decks, driveways and
sidewalks, garage floors, etc., select yellow 15° spray tip.
• For maximum rinsing, for stubborn or hard to reach surface such as second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar, gum, grease, wax, etc.), select red 0° spray tip.
• To apply detergent, applies project specific cleaners to help break down stubborn dirt and grime on a variety of
surfaces, select pink detergent spray tip.
3. Pull back on collar, insert new spray tip and release collar. Tug on spray tip to make sure it is securely in place.
Usage Tips
For most effective cleaning, keep spray tip from 8 -24 inches (20 - 61 cm) away from cleaning surface.
If you get spray tip too close, especially using a high pressure spray tip, you may damage surface being cleaned.
DO NOT get closer than 6 in. (15 cm) when cleaning tires.
Low Pressure
Use to apply
detergent
Fig. 13
Pink
Part No 210500
0
0
White 40
Green 25
3400 PSI
3400 PSI
2.5 GPM
2.5 GPM
12
Fig. 12
0
0
Yellow 15
Red 0
3400 PSI
3600 PSI
2.5 GPM
2.4 GPM
High
Pressure
Form No F021816A
Publicidad
