Publicidad
Idiomas disponibles
Idiomas disponibles
PW30AOV Owner's Manual
Connect Hose and Water Supply to Pump
NOTE: DO NOT run the pump without the water supply connected and turned on. Damage to
equipment resulting from failure to follow this instruction will void warranty.
1. Uncoil high pressure hose and attach quick connect end of hose to base of spray gun. Pull
down on collar of quick connect, slide onto spray gun and let go of collar. Tug on hose to
be sure of tight connection.
2. Similarly, attach other end of high pressure hose to high pressure outlet (B) on pump (See
Fig. 5). Pull down on collar of quick connect, slide onto pump and let go of collar. Pull on
hose to be sure of tight connection.
3. Before connecting garden hose to water inlet, inspect inlet screen (A) (See Fig. 5). Clean
screen if it contains debris or have it replaced if damaged. DO NOT run pressure washer if
inlet screen is damaged.
4. Run water through your garden hose for 30 seconds to clean out any debris.
5. Connect the garden hose (not to exceed 50 ft. (15 m) in length) to the water inlet. Tighten
by hand.
6. Turn ON the water, press red button (C) on the gun and squeeze the trigger to purge the
pump system of air and impurities. (See Fig. 7)
NOTE: Using a One Way Valve (vacuum breaker or check valve) at pump inlet could cause pump or inlet connector
damage.
NOTE: DO NOT siphon standing water for the water supply
• There MUST be at least 10 ft. (3 m) of unrestricted garden hose between the pressure washer inlet and any
device, such as a vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this instruction will void warranty.
WARNING The high pressure stream of water that this equipment produces could cut through skin and its underlying tissues,
resulting in serious injury and possible amputation.
NEVER connect high pressure hose to nozzle extension.
Keep high pressure hose connected to pump and spray gun while system is pressurized.
Always be certain spray gun, nozzles and accessories are correctly attached
Part No 210500
.
Use ONLY cold water (less than 100°F (38°C)).
Fig. 5
9
Fig. 6
Fig. 7
Form No F021816A
Publicidad
