Descargar Imprimir esta página

Periodic Maintenance; General Recommendations; Pump Oil Maintenance - Billy Goat PW30AOV Manual Del Operario

Ocultar thumbs Ver también para PW30AOV:

Publicidad

Idiomas disponibles

Idiomas disponibles

PW30AOV Owner's Manual
MAINTENANCE

PERIODIC MAINTENANCE

Periodic maintenance should be performed at the following intervals:
Maintenance Operation
Change engine oil
Check high pressure hose
Check detergent siphoning/tube filter
Check spray gun and assembly for leaks
Clean debris
Check engine oil level
ENGINE MUST BE LEVEL WHEN CHECKING OR FILLING OIL

GENERAL RECOMMENDATIONS

Regular maintenance will improve the performance and extend the life of the pressure washer. See any qualified dealer for
service.
The pressure washer's warranty does not cover items that have been subjected to operator abuse or negligence. To receive
full value from the warranty, the operator must maintain the pressure washer as instructed in this manual, including proper
storage as detailed in Winter Storage and Long Term Storage.
CLEAN DEBRIS
Daily or before use, clean accumulated debris from pressure washer. Keep linkage, spring and controls clean. Keep area
around and behind muffler free from any combustible debris. Inspect cooling air slots and openings on the pressure washer.
These openings must be kept clean and unobstructed.
Pressure washer parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.
 Use a damp cloth to wipe exterior surfaces clean.
NOTE: Improper treatment of pressure washer could damage it and shorten its life.
 DO NOT insert any objects through colling slots.
 Use a soft bristle brush to loosen caked on dirt, oil, etc.
 Use a vacuum cleaner to pick up loose dirt and debris.
Check and Clean Inlet Screen
Examine the screen on the pump's water inlet. Clean it if the screen is clogged or replace it if screen is damaged.

PUMP OIL MAINTENANCE

Changing Pump Oil
NOTE: When changing pump oil, use only high quality SAE 30 weight oil. Use no special additives.
Change pump oil as follows:
1. Clean area around brass oil drain plug at bottom of pump.
2. Remove oil drain plug. Drain oil completely into an approved container.
3. When oil has completely drained, install oil drain plug and tighten firmly.
4. Clean area around pump oil dipstick. Remove dipstick and fill pump with recommended oil (approximately 12 oz. (0.35
liters)) to the point of overflowing.
5. Install pump oil dipstick.
6. Wipe up any spilled oil.
Part No 210500
First 5 Hours
Every 10 Hrs
14
Every 50 Hrs or
Yearly
Form No F021816A

Publicidad

loading