Publicidad
Idiomas disponibles
Idiomas disponibles
PW30AOV Owner's Manual
ASSEMBLY
1.
Verify oil dipstick (A) has been installed into pump. (See Fig. 1)
2. Place handle (B) onto handle supports (C) connected to main unit. Make
sure holes in handle align with holes on handle supports. (See Fig. 2)
3.
Insert handle carriage bolts (D) through holes from inside of unit and attach a
plastic knob (E) from outside of unit. Tighten by hand.
Add oil to engine crankcase.
4.
. Add fuel to fuel tank.
5
6. Connect high pressure hose to spray gun and pump (See Lubricating O-
Rings Section).
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun (See Lubricating O-Rings Section).
ASSEMBLY CONTINUED
9. Select/attach quick connect spray tip to nozzle extension.
LUBRICATE O-RINGS
LUBRICATING O-RINGS
Lubrication of o-rings is extremely important for installation and operation. The use of a lubricant (petroleum or synthetic grease)
during assembly helps seat o-rings properly and provides an improved seal. It also helps protect the o-ring from damage by
abrasion, pinching or cutting and extends the life of the o -ring.
NOTE: ALWAYS apply a small amount of lubricant on o-rings prior to assembling the garden hose to the pump inlet (A),
high pressure hose to pump outlet (B), high pressure hose (C), spray gun (D), and nozzle extension (E).
Lubricate all connections shown below (Fig. 5), following these instructions:
1. Inspect and clean connecting surfaces prior to lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film is all that is required.
3. Use a small brush or cotton swab to apply grease directly to o-rings where they are not accessible (QC fitting, M22 fitting).
Part No 210500
(See Fig. 3 next page)
Fig. 2
8
Fig. 1
Fig. 3
Form No F021816A
Publicidad
