Charging Process; Autostart; Stand-Alone With Rfid Card Reader - Gewiss JOINON Serie Manual De Instalacion Y Uso

Gewiss

10. Charging process

The steps needed to carry out a recharging session are listed below, on the basis of the various operating modes.

10.1. Autostart

In this mode, the station is always accessible and ready to begin a recharging session as soon as the car connection plug is inserted. To
run a recharging session:
#
1 Check there are no charging station errors
Insert the recharging plug in the required socket-outlet of the
2
Once the connection has been made, the station checks the CP
3
and PP signals to make sure the session can be started
Once the CP and PP signals have been checked, the station locks
4 the plug electrically and mechanically in the socket-outlet. The
5 The car is requesting energy from the station
6
To end the session, disconnect the charging cable inserted in the
7
NB: disconnect the cable from the car side first, to allow the
station to release the connector on the station itself
8 Remove the plug from the socket-outlet on the station
9 If the station encounters no errors, it returns to standby status

10.2. Stand-Alone with RFID card reader

In this mode, the station activates the session once an RFID card enabled for recharging has been swiped across the reader (i.e. added
to the local list of authorised cards).
To add an RFID card to the local list:
#
Swipe the MASTER key across the RFID reader to access the
1
Swipe each single card that you want to add to the list across the
2
RIFD reader (wait for the relative message on the display).
To quit the RIFD card storage menu, swipe the MASTER key across
3
the RFID reader until the standard message appears
To delete an RFID card from the local list:
64
Action needed
station and in the vehicle
recharging session begins
Recharge in progress
car.
Action needed
storage menu
RGB LED status Words on the display
INSERT THE PLUG TO BEGIN THE
Fixed green
INSERT THE PLUG TO BEGIN THE
Fixed green
Fixed green
Flashing blue
RECHARGE IN PROGRESS
Fixed blue
RECHARGE IN PROGRESS
RECHARGE IN PROGRESS
Fixed blue
RECHARGE IN PROGRESS
RECHARGE IN PROGRESS
From fixed or flashing blue
to flashing green
RECHARGE IN PROGRESS
RECHARGE TERMINATED
From flashing green
to fixed green
INSERT THE PLUG TO BEGIN THE
Fixed green
RGB LED status Words on the display
Fixed green
Fixed green
Fixed green
7.55.4.502.0 - Installation and Operation Manual
Charging process
RECHARGE
RECHARGE
PLEASE WAIT
PLEASE WAIT
Ts=0000 Tc=0000
kW=0000 kWh=0000
Ts=0000 Tc=0000
kW=0000 kWh=0000
Ts=0000 Tc=0000
kW=0000 kWh=0000
REMOVE THE CABLE
SESSION SUMMARY
Ts=0000 Tc=0000
SESSION SUMMARY
kW=0000 kWh=0000
RECHARGE
*SAVING*
SWIPE THE CARDS
RECOGNITION
*PLEASE WAIT*
SWIPE THE CARD
TO RECHARGE