Converter Control Lever; Cutting Height Adjustment - inventiv INV T6553 TBV Manual De Instrucciones

7.3 CONVERTER CONTROL LEVER (if fitted)
In the models with drive systems, the converter control lever (if
fitted) allows the operator to regulate forward gear speed. To
do so, move the lever (1) following the indications provided near
the control lever.
IMPORTANT The engine must be running and the drive
engaged when switching from one speed to another.
Do not touch the converter control when the engine is stopped.
Doing this could damage the converter.
NOTE If the machine does not move forward with the lever
in the « » position, simply move the lever to «
immediately return to the «

7.4 CUTTING HEIGHT ADJUSTMENT

8
EN
» position.
• Type I
The cutting height is adjusted by the specific lever (1).
DO THIS WHEN THE CUTTING MEANS IS
STATIONARY.
• Type II
The cutting height is adjusted by pressing the button (1)
and, using the handgrip (2), lifting or lowering the chas-
sis to the desired position.
DO THIS WHEN THE CUTTING MEANS IS
STATIONARY..
» and then