Engine Ignition - inventiv INV T6553 TBV Manual De Instrucciones

D) Preparation for mowing and side discharge of grass (where applicable):
– Lift the rear discharge guard (1) and fit the chute cap (5) in the discharge opening, keeping it
slightly tilted to the right. Fasten it by fitting the two pins (6) into the holes provided until the fas-
tener tooth (7) clicks into place.
– Push the safety lever (3) slightly and lift the side discharge guard (4).
– Insert the side discharge chute (8) as shown in the figure.
– Close the side discharge guard (4) so that the side discharge chute (8) is locked in place.
To remove the deflector cap (5), lift the rear discharge guard (1) and push in the middle to release
the tooth (7).
To remove the side discharge chute:
– Push the safety lever (3) slightly and lift the side discharge guard (4).
– Release the side discharge chute (8).
To remove the chute flap:
– Lift the rear discharge guard (1).
– Push in the middle to release the tooth (7).
10
EN
5
6
7
6
8

8.2 ENGINE IGNITION

• Manual ignition models
Pull the cutting means brake lever (1) against the handle
and firmly tug the knob on the ignition cable (2).
3
8