KOBE CHX30 Serie Instrucciones De Instalación Y Manual De Operación página 9

Vent option installation
1. Choose the require vent option.
NOTE: If the hood is to be installed as
ductless application, please do not remove
any duct knockout located at the top or the
back of the hood.
2. For 7" Round vent installation only:
-
Using a flat-head screwdriver to remove
the 7" duct knockout. (Refer to Figure 5)
-
Attached the 7" exhaust plate using 8
screws (provided). Refer to Figure 6.
3. For 3-1/4" x 10" vent installation only:
-
Using a flat-head screwdriver to remove
the top OR the rear 3-1/4" x 10" duct
knockout. (Refer to Figure 7)
-
Attached the 3-1/4" x 10" exhaust plate
using 6 screws (provided). Refer to
Figure 8 for Top Vent OR Figure 9 for
Rear Vent.
4. For ductless installation only.
-
Remove the recirculating plate located
at the top of the hood, refer to Figure 10.
-
Reinstall the
horizontally as shown in Figure 11.
Figure 5
Figure 6
recirculating plate
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
7