Tips And Recommendations; Questions On The Sunea Screen Io; Replacing A Lost Or Broken Somfy Io Control Point; 5Hvwrulqj Wkh Ruljlqdo Frq¿Jxudwlrq - SOMFY Sunea screen io Guia De Instalacion

Ocultar thumbs Ver también para Sunea screen io:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. TIPS AND RECOMMENDATIONS

8.1. Questions on the Sunea screen io?

2EVHUYDWLRQV
The awning does
The wiring is incorrect.
not operate.
The motor is hot.
An incorrect cable has been used.
The io control point battery is low.
The control point is not compatible.
The io control point used has not been
programmed into the motor.
The awning stops
The crown is incorrectly positioned.
too soon.
The end limits have been incorrectly
set.

8.2. Replacing a lost or broken Somfy io control point

Refer to the corresponding guide.
8.3. 5HVWRULQJ WKH RULJLQDO FRQ¿JXUDWLRQ
This reset deletes all control points, all the sensors and all the end limit settings, and resets the
motor's direction of rotation and favourite position (my). However, the advanced functions («Back
release», «Closing force») are maintained.
Only switch off the power for the motor to be reset.
1) Put the awning in the middle position (if possible).
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the awning moves for
several seconds.
If the awning is at the upper or lower end limit, it will
make a brief movement.
 +ROG GRZQ WKH 352* EXWWRQ WKH DZQLQJ ZLOO PDNH D ¿UVW
movement followed by a second a few instants later. The
PRWRU LV FRQ¿JXUHG ZLWK WKH IDFWRU\ VHWWLQJV
- Repeat the procedures from the &RPPLVVLRQLQJ»
section
Copyright © 2011 Somfy SAS. All rights reserved.
Possible causes
Solutions
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check the cable and ensure it has 3 leads
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or program
this control point.
Fit the crown correctly.
Readjust the end limits.
1
5 sec.
3
15 sec.
5
6
Sunea screen io
2
2 sec.
4
2 sec.
my
11

Publicidad

Tabla de contenido
loading

Tabla de contenido