Water Connection; Hydraulic Connection - Ascaso BABY T Manual De Usuario

7 – Water connection
This machine has different connection options, either to the MAINS or the RESERVOIR,
depending on the model, whether ZERO or PLUS. Before starting it up, check the
model of your machine.
The Baby T ZERO only has the option of using
water from the RESERVOIR. You will find this
on the right-hand side of the machine. To start
it up:
1. Fill the reservoir with fresh water.
2. Check that the water inlet pipe is fully
submerged in the reservoir.
3. Check that the reservoir is filled with
enough water. If you operate the coffee
machine without water, it can damage the
pump.
IMPORTANT!
The machine has an electronic water level control in the reservoir; once the water
has gone below the minimum level, a warning light will appear (see Section 12).
We recommend using water with a low mineral content. The quality of the water
affects the flavour and quality of the coffee, and also helps to prevent malfunctions
in the future. Check out our special anti-limescale filters (optional).
Recommended water parameters for using with a mains connection:
T.D.S.
Total hardness
Total iron
Free chlorine
Total chlorine
12
MANUAL BABY T ENG-ESP_DE 2020 .indd 12 MANUAL BABY T ENG-ESP_DE 2020 .indd 12
90-150 ppm
70-100 ppm
0-0.22 ppm
0-0.05 ppm Mains pressure
0-0.1 ppm
pH
Alkalinity 40-80 ppm
Chlorine 0-30 ppm
0.1-0.6 MPa
Flow rate 8 l/min
6.5-8
22/09/2020 16:29:11 22/09/2020 16:29:11