Stand-Alone Operation; Master/Slave Operation - HQ-Power VDPL300QF Manual Del Usuario

• Familiarise yourself with the functions of the device before actually using it. Do not allow
operation by unqualified people. Any damage that may occur will most probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Description
1. safety chain fixation ring
2. DMX input
3. DMX output
4. DIP switches
5. IEC cord input/fuse
6. sensitivity adjustment knob
7. controller input (VDPL300RC)
5. Installation
• Choose a suitable mounting spot. Mount the fixture in the desired angle using the included
bracket. Connect the IEC power cord to the mains. Disconnect after use.
Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Use

Stand-Alone Operation

Your VDPL300QF can be used without controller. Set all DIP switches to OFF. Adjust the sensitivity
of the internal microphone through the adjustment knob on the back panel.

Master/Slave Operation

The master/slave mode enables you to connect several fixtures to one single master fixture. All
slave fixtures will work synchronously with the master fixture.
Set all DIP switches on the master unit to OFF; set DIP switches 1 and 10 on each slave fixture to
ON.
VDPL300QF 3 HQPOWER™