User Menu; Pause Menu; Priming Menu - Aqua HC151 PH-RX Manual De Programación

HC151 PHRX
Digital multifunction solenoid metering pump

3. USER Menu

The USER menu is the menu that is displayed when starting the pump. When you turn on the pump the
following information is displayed:
AQUA spa
HC151rev 1.0
WORKING MODE
ENTER ENTER
PARAMETERS
WORKING MODE
3.1

PAUSE Menu

The pause menu puts the pump in stand-by mode. You have to press and hold the Down key
Enter key to put the pump in pause. To remove pause you have to press and hold the Enter key.
If the pump is paused, the menu appears:
WORKING MODE
3.2

PRIMING Menu

The user can perform the priming operation by this menu. To access this menu, you must press and
hold the Up key
expiry of 5 minutes, just press Up key. The menu appears:
ADSP9500092
Displays information relating to the pump as a revision, model etc. ... for a
few seconds when powered
This shows working mode (constant, 1XN ...) set in the programming menu.
Parameters will be displayed on the working mode set. The user can
modify these parameters if and only if it has been enabled by the admin
(programming menu).
Pressing ENTER button enables you to scroll parameters of working
mode.
HC151
PAUSE
Pressing and holding the Enter key, you return to the USER menu
ENTER
and Enter key. Priming starts for 5 minutes. If you want to stop priming before the
HC151
PRIMING
WORKING MODE
14/04/2015 Rev. 1.0
Finished priming, the working mode menu set
is displayed
ENGLISH
and
32/123