Tractor Head Coupling - JF 9000 S2 Manual Técnico De Operación

Preparador y repartidor de ensilaje
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION TECHNICAL MANUAL - FORAGE WAGON JF 9000 S2

4.2- Tractor head coupling

Note:
Coupling should be done on a flat and even
place
To couple the head to the tractor, follow the instructions
below:
a) Approximate the tractor aligning the draw-bar (1) with
the coupling terminal (2) of the wagon.
NOTE: Tractor draw-bar must have head (according to
illustrated), preventing the wagon from raising up.
b) In case there is need, lower or rise the head through
the stand jack (3).
c) Install the coupling pin (4) and lock it with a counter-
pin, preventing accidental uncoupling.
d) Pull the locking pin (5) and put the stand-jack (3) in
horizontal position. After that, reinstall the pin to lock the
stand-jack.
NOTE: When the machine is running, the stand-jack
should be in work position (horizontal).
e) Check the wagon leveling and adjust as needed,
according to described in the previous page.
1
3
4
2
5
17

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido