GYS DIAG-STARTIUM 60-12 Manual De Instrucciones página 14

Translation of the original instructions
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
GENERAL DESCRIPTION
DIAG-STARTIUM products are designed for charging and starting 12V (6 elements) lead acid batteries (electrolyte, Gel
and AGM) for the model 60-12 and 6V (3 elements), 12V (6 elements) and 24V (12 elements) for the model 60-24:
Assembly - handle and wheels :
POWER SUPPLY
Check that the power and protection (fuse and / or circuit breaker) are compatible with the current required. The
appliance must be positioned so that the plug socket is accessible.
It must be connected to a grounded outlet according to the following recommendation:
Power supply
Protection
Charging
power
The recommended cross-section for an extension is : 3 x 2,5 mm².
CONNECTION AND DISCONNECTION
• Before any connection to a vehicle battery, make sure
that the booster isn't connected to the mains and that the
booster's switch is set to OFF.
• Locate the + and - battery terminals. (polarity reversal can
damage the fuse).
• Keep the cables away from hot or sharp surfaces. Separate
the 2 cables properly and avoid pinching them.
Once the connector is plugged on «12V» or «24V», a LED switches on under the corresponding interface to confirm the
selected voltage input. If the selected voltage does not match the battery voltage, the charge cannot start.
14
DIAG-STARTIUM 60-12 / 60-24
DIAG-STARTIUM 60-12
230V - 1 ph
2000 W
charge
Starting 10 000 W
DIAG-STARTIUM 60-24
16 A
230V - 1 ph
16 A
2000 W
10 000 W
EN