GYS DIAG-STARTIUM 60-12 Manual De Instrucciones página 15

Ocultar thumbs Ver también para DIAG-STARTIUM 60-12:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
Translation of the original instructions
Diag-Startium 60-12
Start and charge a battery in-situ :
In the event that the negative terminal is plugged onto the car's chassis :
Connect the red clamp to the battery's positive terminal.
1.
2.
Connect the black clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the
fuel/exhaust pipe.
Connect the device to the mains.
3.
4.
Choose the user mode, charge speed and switch the DIAG-STARTIUM on.
5.
After use, set the switch to OFF, disconnect the charger from the mains then remove the black clamp,
followed by the red clamp.
Some vehicles have the positive terminal plugged onto the car chassis, in this event :
Connect the black clamp to the battery's negative terminal.
1.
2.
Connect the red clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the
fuel/exhaust pipe.
Connect the device to the mains.
3.
Choose the user mode, charge speed and switch the DIAG-STARTIUM on.
4.
5.
After use, set the switch to OFF, disconnect the charger from the mains then remove the red clamp first
and the black clamp last.
Charging a battery when disconnected from the vehicle :
Connect the red clamp to the battery's positive terminal and the black clamp to the battery's negative
1.
terminal.
Connect the device to the mains.
2.
Choose the user mode, charge speed and switch the DIAG-STARTIUM on.
3.
4.
After use, set the switch to OFF, disconnect the charger from the mains then remove the red clamp first
and the black clamp last.
USE IN CHARGING MODE (SEE INTERFACE)
Charging
capacity
Precautions before use
• Choose a sufficiently ventilated area
• Remove the caps on the battery (if any) and make sure the water level (electrolyte) is sufficient. Otherwise add the
deionized water and carefully clean the battery terminals.
• Check that the battery capacity in ampere-hours and voltage in volts are compatible with your charger.
DIAG-STARTIUM 60-12 / 60-24
DIAG-STARTIUM 60-12
6V
12V
20 - 900 Ah
24V
Diag-Startium 60-24
DIAG-STARTIUM 60-24
-
-
20 - 900 Ah
20 - 900 Ah
20 - 525 Ah
EN
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Diag-startium 60-24

Tabla de contenido