Publicidad
Idiomas disponibles
Idiomas disponibles
Slip the main post (B) over the boss (A)
on the main body in the direction of the
arrow, Fig.7, making sure not to snag
any of the cables.
ATTENTION:
Make sure that the tension control (62)
functions
correctly
clockwise and anticlockwise.
Fit the screws (16), along with the
washers
(17)
previously, Fig.7, and tighten securely.
Fit front screws (48) with the grower
washer (17), the corrugated washers
(49), fit the washer (15) and the nut
(59) on the other end of the screw and
tighten securely.
Lower the bottom trim section for the
main post (B) down over the boss
section of the main body (A), Fig.8.
6. FITTING THE FEET.-
Take the left foot (30), insert tube
(105) and align the holes on the two
tubes on the inside of tube (18) in the
direction of the arrow, Fig.8.
Next, take the knob (103) and screw it
clockwise onto tube (18).
Then take the right foot (96) and insert
the tube into tube (94) in the direction
of the arrow, Fig.8.
Next, take the knob (103) and by
aligning the holes on the two tubes
screw it clockwise onto tube (94).
7. FOCUS BAR SETTINGS.-
To adjust the angle of the feet for
doing exercise and the length of the
focus bar swing, turn knob (103)
anticlockwise to loosen it slightly, hold
the foot and pull the knob outward.
Sliding tube (105) into tube (18) will
reduce the length of focus bar swing
and pulling the tube (105) out will
increase the length of the swing.
by
turning
and
(49),
removed
8
FITTING
FOCUS BARS.-
Take the top left bar (5) (marked with
the letter "L"), connect the terminal (8)
coming out of the bottom of the bar
with the terminal (55) coming out of the
bottom bar. Fig.9.
it
Insert the top bar onto the bottom left
focus bar (18), lining up the letters (L),
Fig.9, fit the screws (7), the curved
washers (9) and the cap nuts (10) and
tighten securely. Now go through the
same procedure for the top right focus
bar (92).
9. FITTING THE ELECTRONIC
MONITOR.-
ATTACHING THE FEEDBACK CABLE.
Take hold of the cable (53), which is
sticking up out of the main post (B),
Fig.10, and plug it into the connector
(53a) at the back of the electronic unit
(43), as shown in Fig.10
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(54 & 55), sticking out of the main post
(B), and plug them into the connectors
(54a & 55a) located at the back of the
monitor (43), as shown in Fig.10.
ATTACHING THE MONITOR.
Release screws (44), Fig.11, at the
back of the monitor.
Next, slide the front of the monitor onto
the plate on top of the main post (B) in
the direction of the arrow, Fig.11, push
the cables down into the main post
making sure not the pinch any of the
cables.
Replace
removed previously.
Once you have checked that the
monitor works correctly, go on to fit the
trim covers to the handlebar.
15
THE
UPPER
the
screws
(44)
Publicidad
