BH FITNESS G-238 Instrucciones De Montaje Y Utilización página 19

Fig 1 Parts list.
(2) Right focus bar or arm
(5) Main body.
(12) Bottom trim covers, left and right
(R) for the knuckle joints on the focus
bars
(14) Electronic monitor.
(30) 4 Focus bar spindle covers (L-R)
(31) Bottom trim covers, left and right
(L) For the knuckle joints on the
focus bars
(38) Rear stabiliser
adjustable feet
(44) Left focus bar or arm
(55) Bottom cover, left foot
(55) Bottom cover, right foot
(57) Left footrest
(77) Transformer, 6V
(79) Front stabiliser bar with wheels
(99) Right footrest
(100) Main post.
Fig 2 Screws and fasteners
(4) Allen screws M-8x36
(3) Self-locking nuts M-8
(7) Flat washer M-8
(8) Spring washer M-8.
(13) Screws M-3x20
(29) Screws M-8x25.
(9) Allen screws M-8x20
(56) Screws DIN 603 M-10x45
(32) Self locking nuts M-10.
(33) Flat washer M-10
(49) Screws M-5x10
(21) Screws M-5x16
(A). Combination box spanner.
(B) Allen key 5mm.
Allen key 6mm.
(C)
2. FITTING THE STABILISER
BARS.
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
bar with
19
First, lift the front of the machine and
rest it on a prop, such as the
packaging that you have just removed.
Bring the front stabiliser bar with
wheels (79) to the main body (5)
positioning the wheels at the front of
the unit, figure 3, insert the screws
(29), fit the flat washers (7) and spring
washer (8), and tighten securely.
Carry out the same operation to attach
the rear stabiliser bar. Lift the rear of
the machine slightly and rest it on a
prop, such as the packaging that you
have just removed.
Take the rear stabiliser with adjustable
feet (29), and line up the dots (3), fig
3. Insert the screws (58), fit the
washers (59) and nuts (55), and
tighten securely.
IMPORTANT: It is advisable to
retighten these screws after one
month of using the machine.
3. FITTING THE MAIN POST
Mod. G-238.-
Take the main post (100) and remove
the screws (29) the washers (7) and
spring washers (8) from the bottom of
the post (100). Fig.5.
Next, bring the main post (100) up to
boss (D) on the main body (5), Figure
5.
Take the tip of the tension cable (76)
and insert it in through the bottom of
the main post (100) in the direction of
the arrow so that it comes out through
the top, see Fig. (5A).
Connect terminals 66 with 34, Fig. (5B).
Slip the main post (100) over the boss
(D) on the main body (5) in the
direction of the arrow, figure 5, making
sure not to snag any of the cables.
Refit the screws (29), the washers (7)
and the spring washers (8) that you
removed previously, Fig. 5, and