Main Reflector Position (Zoom); Flash Exposure Correction (Ev) - Metz MECABLITZ 58 AF-1 digital Manual De Instrucciones

cannot be changed.
• Press the „Para" button (Parameters) until the desired flash parameter (see
below) appears on the LC display.
The following parameters are available:
TTL/P-TTL/
M/M HSS
P-TTL-HSS/A/SB
— — N
— — f
— P P
Zoom Zoom Zoom
EV — —
• Set the desired value using the +/— buttons. The setting takes effect immedia-
tely.
• Press the „Return" button to change the LC display back to the normal
view. If the „Return" button is not pressed, the display will change back to
the normal view after about 5 seconds.
Depending on the system, the aperture setting will not be shown on the
display of the flash!

6.2 Main reflector position (Zoom)

If there is no digital data transfer between the camera and flash unit, the reflector
positions
24 mm - 28 mm - 35 mm - 50 mm - 70 mm - 85 mm - 105 mm (35mm format
24 x 36) can be set manually.
MZoom will then appear in the LC display.
100
Table 1
Number of strobe flashe
Strobe flash frequency
Manual partial light output
Mainreflektor position
Manual flash exposure correction
Setting procedure:
• Press the „Para" button (Parameters) until „Zoom" appears on the LC display.
• Set the desired value using the +/— buttons. The setting takes effect immedia-
tely.
• Press the „Return" button to change the LC display back to the normal
view. If the „Return" button is not pressed, the display will change back to
the normal view after about 5 seconds.
During digital data transfer between the camera and flash unit, the main reflec-
tor positions are adjusted automatically.
AZoom will then appear in the LC display.

6.3 Flash exposure correction (EV)

Manual flash exposure correction (EV) can help offset extreme differences in
contrast between the subject and background. Corrections from -3 f-stops (EV) to
+3 f-stops (EV) can be made, in 1/3 increments (also see 11.5).
Flash exposure correction is only activated in the TTL and P-TTL flash
modes if the camera supports this function (see the camera's operating
instructions)! Flash exposure correction is activated in automatic flash
mode A irrespective of the camera model!
Setting procedure:
• Press the „Para" button (Parameters) until „EV" flashes on the LC display.
• Set the desired EV value using the +/— buttons. The setting takes effect imme-
diately.
• Press the „Return" button to change the LC display back to the normal
view. If the „Return" button is not pressed, the display will change back to
the normal view after about 5 seconds.