Wireless P-Ttl - Remote System; Activating The Remote Flash Mode As Master - Metz MECABLITZ 58 AF-1 digital Manual De Instrucciones

Some cameras support the AF measuring beam in the flash unit only with the
camera's central AF sensor. If a peripheral AF sensor is selected, then the AF
measuring beam will not be activated in the flash unit.

19. Wireless P-TTL - remote system

The wireless P-TTL remote system consists of a Master or Controller flash unit on
the camera and/or the built-in camera flash (see the camera's operating instruc-
tions) and one or more Slave flash units. The Slave flash unit(s) are controlled via
wireless technology by the secondary reflector of the Controller or Master flash
unit. The light of the secondary reflector does not contribute to the exposure of
the shot.
When the master function is activated, the built-in camera flash controls the
Slave unit(s) with its flash light and at the same time contributes to exposing the
shot.
When the controller function is activated, the built-in camera flash only controls
the Slave unit(s) with its light. The light of the Controller does not contribute to the
exposure of the shot.
The light of the Slave flash unit is controlled by wireless technology via flash pul-
ses from the Controller or Master flash unit on the camera (P-TTL remote).
To prevent multiple remote systems in the same room from interfering with one
another, there are four independent remote channels to choose from (Channels 1
to 4). Master and Slave flash units belonging to the same remote system must be
set to the same remote channel. The Slave flash units must be able to receive the
light from the Master or Controller flash unit using the integrated remote mode
sensor .
When the controller or Slave flash unit are set to remote flash mode, the
flash range is not indicated on the flash unit's display.

19.1 Activating the remote flash mode as master

• Press the "SEL" button repeatedly until "Select" appears on the display.
• Use the UP and DOWN buttons to select "Remote" from the menu. The
selected menu option is indicated by a dark bar.
• Press the "Set" button to confirm the selection of "Remote".
• Use the UP and DOWN buttons to select "Remote Master/Control". The
setting is effective immediately.
• Press "Return" repeatedly to return the display to normal. If the "Return"
button is not pressed, the display will switch back to normal automatically
after approximately 5 seconds.
• Press the "Para" button repeatedly until the "Mode" button is also displayed.
• Press the "Mode" button repeated until "Master" appears on display.
• The setting is stored automatically. The display will switch back to normal auto-
matically after approximately 5 seconds and the "Mode" button is cancelled in
the display.
Setting the parameters
• Press the "Para" button repeatedly until the desired parameter appears on the
display. Here it is possible to make settings for...
- EV: Flash exposure correction; -3 EV to +3 EV in increments of one third are
possible
- Channel: Remote channel; channels 1 to 4 are possible
- and MZoom: Reflector position; 24mm (18mm with wide angle attachment)
up to 105mm are possible.
• Use the (+) and (-) buttons to make the desired settings.
• Store the setting with the "Return"
pressed, the settings will be saved automatically after approximately 5
seconds.
button. If the "Return" button is not
113