Panasonic AK-HC1800G Manual De Instrucciones página 18

How to install
 Example where the camera is mounted on a ceiling or wall
(Ceiling)
Always mount
using the
anchor bolt.
Notes
 When installing the mounting bracket or attaching one end of the drop-prevention
wire to the ceiling or a wall, be absolutely sure to use the anchor bolts, and ensure
that the withdrawal strength of the installation surface is at least ten times the total
mass of all units installed, including the mounting bracket, camera, lens, and cables.
 Ensure that the total mass, including the mounting bracket, camera, lens and cables,
does not exceed 8 kg (17.6 lbs.).
 Ensure that a drop-prevention wire is installed in such a way that the drop distance
does not exceed 150 mm.
 Tighten the mounting screws using the torque levels shown in the table to the below,
and then check for play and unsteadiness.
Screws
Mounting screws (1/4-inch screws)
Mounting screws (/8-inch screws)
 Do not use an impact driver as doing so may cause damage to the screws.
Be sure to ask the dealer for the installation,
adjustment and connection of this equipment.
Secure the end of the wire onto the M6 or M4 anchor bolts by
tightening nut or secure it by tightening the M6 or M4 bolts.
Mounting screw for wire
(Inch screw: 1/4-20UNC) (supplied)
Spring washer (supplied)
Flat washer (supplied)
Drop-prevention wire (sold separately)
Camera mounting bracket [*]
When using inch screws (1/4-20UNC), drill
holes with a 7 mm diameter (see page 11).
Flat washers [*]
Spring washers [*]
Mounting screws [*]
(Inch screws: 1/4-20UNC)
When using inch screws (3/8-16UNC), drill
holes with a 10 mm diameter (see page 11).
Flat washers [*]
Spring washers [*]
Mounting screws [*]
(Inch screws: 3/8-16UNC)
Clamping torque
.0 N • m (0 kgf • cm)
1 N • m (10 kgf • cm)
- 17 (E) -
[*]: Procured locally