EHEIM 2250 Manual De Instrucciones página 8

F Place the filter below the water level, ideally beneath the aquarium.
Take care to ensure that the pump receives sufficient ventilation.
Pressure side installation:
Secure the jet pipe to the rear aquarium panel with the aid of the two
suction pads, at a sufficient distance from the surface to ensure good
oxygenation (1) or surface movement (2), depending on type of instal-
lation. The outlet elbow should be secured to the jet pipe with a short
piece of hose, the elbow being led over the edge of the aquarium. Con-
nect the outlet elbow and pressure side union of the filter with hose.
G Suction side installation:
Fit the intake pipe and strainer together, connect the elbow with a short
piece of hose and secure the intake pipe assembly to the aquarium
panel with 2 suction pads. Connect the elbow to the intake side hose
connector on the filter with hose. (See also fig. J).
Operation:
Release the pressure hose from the jet pipe. By suction on pressure
side (or using the EHEIM suction device, order no. 4003540), draw
water through the end of the hose and over the rim of the aquarium
until the filter is functioning fully of its own accord. Now reconnect the
pressure hose to the jet pipe and switch on the filter by plugging it into
the power supply.
H Always disconnect the power supply before carrying out any clean-
ing or other operations on the filter.
To clean the filter, pull off the hose from the intake pipe and empty the
canister into a bucket or allow it to drain. Then, and only then, remove
the filter cover. Remove filter compound (clean or replace) and clean
the appliance. For the care of the centrifugal pump, refer to the accom-
panying pump instruction leaflet.
The filter canister on model 2260 can be emptied direct by attaching a
hose to the drain tap, if required.
Cleaning of the pump:
Remove the connection bend, unlock the pump lid and remove all parts
as shown on the drawing. Clean the pump pipes with a set of cleaning
brushes (order no. 4009570 for 2250 or 4009580 for 2260). Clean the
pump parts under running water and then reassemble in the same
order.
I Diagram showing assembly of the safety hose.
Note: All hose connections must be checked at regular intervals for
correct fitting.
Only to be used indoors.
connect the mains plug.
cannot be replaced. If the wiring is damaged, the pump must
no longer be used.
When working in water, dis-
The connection part of this pump