TechniSat TechniVision 22 ST Manual De Instrucciones página 12

Antenna configuration (DVB-S)
If you selected Yes for DVB-S in the "Selection of reception signals" window, this installa-
tion step allows you to set the digital receiver to match the configuration of your satellite
antenna. If you selected No for DVB-S, proceed to the next step, Antenna configuration
(DVB-T).
If you would like to select the standard settings for the antenna, press the green
>
function button, Accept.
Then continue to the next step, Antenna configuration (DVB-T).
If your receiver system is not configured to the standard settings, press the yel-
>
low function button, Modify.
> Now enter the antenna settings of your reception system and confirm by pressing
the green function button, Accept.
> In the next step, check to make sure that this configuration is correct and press the
green function button, Accept, to confirm these settings.
Antenna configuration (DVB-T)
If you selected Yes for DVB-T in the "Selection of reception signals" window, this installa-
tion step allows you to select the best position for your DVB-T antenna using the channel
spectrum display.
To switch the antenna power on or off, use the up/down arrow buttons to
>
select Antenna supply and then use the right/left arrow buttons to toggle
the antenna supply on and off.
> Now position your DVB-T antenna in the location for which the channel spectrum
displays the highest levels of reception and confirm by pressing the green func-
tion button.
12