Page Selection - TechniSat TechniVision 22 ST Manual De Instrucciones

5.3 Teletext
You TV set is equipped to display teletext information. This is only possible for pro-
grammes that transmit teletext data.
For digital programmes, you can use either the teletext decoder in the TV set or the
decoder in the integrated DVB receiver.
Teletext information from analogue programmes can only be displayed using the teletext
decoder in the TV set.
Please note that the remote control must be in TV mode to operate the teletext decoder
in the TV set and it must be in DVB mode to operate the teletext decoder in the DVB
receiver. Press either the TV or the Digital button two switch between TV mode and
DVB mode.
Unless otherwise specified, the procedures for using TV and DVB teletext are the same;
thus they do not require individual instructions.
5.3.1 Switching teletext on and off
> Select the programme for which you would like to view teletext.
Press the TXT button to switch teletext on.
>
If the selected programme transmits teletext information, it will be displayed on
page 100 (overview).
Press the TXT button again to switch to mixed mode. Here, the TV image is dis-
>
played as the background for the teletext.
Press the TXT button once again to switch teletext off teletext.
>

5.3.2 Page selection

Use the number buttons 0 through 9 to enter the three-digit page number.
>
Your entry is displayed in the upper left-hand corner of the display. Because not all
teletext pages can be transmitted simultaneously, it may take a few seconds for your
device to find the page and display it on the television screen.
or
Use the red or green button to move forward or backward one page
>
at a time.
Press the yellow function button to display the teletext group displayed in the yel-
>
low field and press the blue function button to display the teletext block displayed in
the blue field.
16