Petsafe Staywell Infra-red 800 Serie Manual Del Usuario página 4

b) In Walls
Fits brick walls
Follow the instructions for "Wood and PVC/uPVC/Metal", by using the
enclosed cutting template. Please note that additional tools, materials and
competent DIY skills may be required.
FOR SAFETY REASONS IT IS NOT RECOMMENDED TO FIT THIS
PRODUCT IN GLASS.
Fitting the dog door
Your Staywell dog door is fi tted with the 4 way locks and security
barrier on the inside of your house.
Before fi tting you should remove the security barrier and unlock the pet
door. To do this, push fi t the 4 way locking turning handles into position
making sure they are both in the same position. (Fig. 4). Turn the handles
whilst pushing the barrier as indicated. This will allow the security barrier to
be removed. (Fig. 5).
FIG.4
3
Temporarily place the dog door in the hole and mark screw hole positions
which can be found under the u-shape on the dog door. (Fig.6).
Remove the dog door and drill the holes with a 4.5mm (
From the inside of the house, position inside frame. Insert screws through
the drilled holes. If the screws are too long they may need to be cut down
to match the depth of your door. Using over long screws may damage the
pet door. The screws should be removed from the cat fl ap before cutting.
File down to ensure there are no sharp edges.
Position the outside frame onto the outside of the house and insert the
hexagonal nuts, through the holes provided, as far as they will go until they
'lock' in the hexagonal housing.
Once locked in position tighten the bolts, a little at a time, until both frames
lie fl ush with the door. Make sure that the dog door is vertical (Fig.8).
FIG.6
FIG.5
Your Staywell dog door is now ready to use.
/ ") drill bit. (Fig.7).
3
16
FIG.7
4.5mm
( 3 / ")
16
FIG.8