Diagnostic Messages - Glass 1989 SPA Manual De Uso

MODE
To change the mode , press the "+" button
then "Light ".
In standard mode, the temperature is
maintained at the set value. When you
switch to Standard Mode display shown
"St".
Economy Mode heats the spa to the
When the temperature is not current."Ec"
will display water temp is not current, and
will alternate with water temp when the
pump is running.
In the "sleep" mode the water is heated
to a temperature close to the set - within
temperature is not current, the display
shows "SL"; this indication toggles the
display of the value of temperature, while
the pump is running.
PRESET FILTER CYCLES
T e first reset filter c cle be ins
minutes after t e s a is ener i ed w ile
t e second set lter c cle be ins
later. Filter duration is ro rammable for
and
duration is ours.
To ro ram ress
- to ad ust. Press
ro rammin rocedure.
W en filterin t e
low s eed and t e o one enerator (if
installed) is enabled
The ozone generator aids in oxidizing
the organic substances that get in the
water, and therefore reduces the need
for chemical products for water treatment.
The ozonator runs automatically and is
contingent on the activation of the pump
hydromassage or even one spotlight is on.
This is because there is probably a person
in the tub. ~30 minutes after the functions
are shut off, the ozonator begins operating
ours
ours t e default
t en ets . Press
ets to e it t e
um o erates at
11
increase in the performance of the MySpa.
water purity which is greater than that
(see guide accompanying the product).
on.
AUTOMATIC POLLING
(only in standard mode)
The pump will run for 1 minutes to check
the temperature :
- Every 30 minutes
- whenever the set temperature is raised

DIAGNOSTIC MESSAGES

Message " "
No message on display. You power has
been cut off to the spa
- T e control anel will be disabled until
ower returns . S a settin s will be
reser ed until ne t ower-u .
Message "_ _"
- After t e um as been runnin for
minutes current water tem erature will
be dis la ed.
Message "HH"
has shut down.* One of the sensors
at the heater.
- DO NOT ENTER THE WATER . Remo e
t e s a co er and allow water to cool .
Once t e eater as cooled
us in an button if s a does not reset
s ut off t e ower to t e s a and call our
dealer or ser ice center.
EN
reset b