Temperature Selection ; Time Of Day - Glass 1989 SPA Manual De Uso

combine with a scene (1 or 2, 3, 4) by
means of "Scenes" menu.
OK" key pressed for more than
three seconds.
from a confirmation message which
EN
appears on the lower left hand side of
display.
ACCESS TO MINIPOOL SETTINGS
Select "Settings" in the main menu, then
submenu of functioning
parameter setting.
Esci
If no choice is made or no submenu is
actively entered, after 30 seconds the
display returns automatically to main
menu.
TEMPERATURE SELECTION - Selection
of the water temperature operative
range.
By selecting the above parameter, the
temperature setting fluctuation range,
which can be reached from main menu
screen, is enabled.
By selecting "High" the choice of a
temperature range from 26.5°C up to 40°C
is enabled.
By selecting "Low" the choice of a
temperature range from 10°C up to 37°C
is enabled.
The selection between two available
temperature ranges is made by positioning
the selection string in correspondence to
the line "Temp Range" and choosing the
High or Low value through the "OK" key.
The reasons for choosing to operate
in various temperature ranges can be
different.
OK", key to enter the
Settaggi
Alto
Sel. Temp
Pronto
Modalità Risc.
Ora/Minuti
Filtrazione
Normale
Inverti pannello
Chiuso
Attesa
Utilità
Preferenze
Informazioni
Examples: Summer/winter use.
Settings of a rest temperature and an
operating one.
The selected temperature range is shown
on the main menu window.
In any case, the antifreeze sensor remain
always enabled and carries out the
corrective actions to prevent water from
freezing in the minipool or its pipes.
HEAT MODE – Minipool heat mode.
This parameter permits to select the
operating mode for minipool heating.
There are two options:
"Ready Mode" indicates that the minipool
heating is predisposed to operate
everytime it is required.
"Rest Mode" indicates that the minipool
heating is predisposed to operate only
during the filter cycle programs. It
permits to limit the minipool power draw
when requiring to avoid the electricity
consumption for heating at certain time
slots.
duration is not enough to reach the
required wate temperature, it will be never
possible to use the minipool in the desired
function only together with quite long-
lasting filtering programs according to
minipool operative functions and its water
content.
The lower window on the right side of
"Menu" screen identifies the selected
operating mode ("Ready Mode" and
"Rest Mode") and possible ongoing water
heating activities ("Heating") at any time.
TIME OF DAY - Time setting
time or in case power supply is cut off for
quite long periods, it is necessary to set
the time functions.
This event is shown on the control panel
display with the message "Set the time".
The correct time setting is the basic
program functioning.
To set the time, from the "Settings" menu,
24
Rest Mode"