Cleaning Cycle - Glass 1989 SPA Manual De Uso

It has a pre-set duration of 1 hour. To
activate the system "standby" mode,
access the "HOLD
with the temperature key "UP". Messages
starting the Time out (the message
EN remains active until the time elapses). To
deactivate this function before the end
of the Time out, press "UP" or "LUCE"
(LIGHT) (the display shows the message
"DONE" to indicate the system restart).
"FILTR 1" - "FILTR 2":
FILTRATION CYCLES 1-2
and "
These cycles are set (with 15-minute
increments) by adding the start time and
duration of the function (the control panel
calculates the end of the cycle and it
displays it automatically).
NOTE:
default "
" menu and press "UP" to activate "ON"
SET FILTRATION 1
MAIN SCREEN
confirm settings
".
" - "OFF".
START TIME flashes
FILTRATION TIME
FILTRATION END
RECIRCULATION PUMP
The recirculation pump switches on when
the system controls the water temperature
during the filtration cycles, anti-freeze
appear function or when the Jets pump is active.
with the recirculation pump.
the Pump activates for a short time to
clear the pipes and maintain the quality
of the water.
ATTENTION: the ozone deactivates
"
whereas it remains ACTIVE ONLY IF
THE CHROMOTHERAPY IS ACTIVE.
ANTI-FREEZE
If the temperature sensors inside the
heater detect very low temperature, the
pumps activate automatically guaranteeing
an anti-freeze effect. The pumps work
continuously or periodically, depending
on the requirements.
FILTR

CLEANING CYCLE

A cleaning cycle (with pre-set duration)
starts once a pump has been activated
and when the use time has elapsed or
Set HOURS Set MINUTES
Set duration
confirm settings
Or wait
a few seconds
18
Or wait
a few
seconds