First Start-Up - Glass 1989 SPA Manual De Uso

EN
1. Display
2. JETS (whirlpool) key
3.
4. "Down" key / temperature
5.
6.

FIRST START-UP

draining:
operation level. Make sure all the valves
and water jets of the hydraulic system
the air to be eliminated from the system
on, the top part of the display provides
After the sequence of activation numbers,
the system enters the priming mode.
This procedure lasts 4-5 minutes and is
indicated with the following messages:
"RUN" "PMPS" "PURG" "AIR" "-- -- -- --"
Press the "Jets" key once to activate the
recirculation pump, then press it again to
activate the Jets pump.
If the pumps are not primed after two
minutes and water does not come out,
switch the pumps off and repeat the
DISPLAY FUNCTIONS - Model B
14
procedure.
NOTE: When you switch off and restart the
pumps, these will undergo a new priming
procedure. Do not repeat the operation
more than 5 times. If the pumps fail to
prime, switch them off completely and call
the after-sales centre.
IMPORTANT: pumps are not allowed
to run if the priming procedure is not
completed. Otherwise the system
overheats damaging the pumps.
ATTENTION: the priming procedure
prime within this time.
KEYBOARD OPERATION
WHIRLPOOL
Press the "JETS" key once to switch the
whirlpool on or off.
The whirlpool has a pre-set time duration
of approximately 15 minutes.
LIGHT - CHROMOTHERAPY
Press the "LUCE" (LIGHT) key to switch
the chromotherapy option on and off.
pre-set colour cycle by pressing "LUCE"
(LIGHT) several times.