Glass 1989 SPA Manual De Uso página 69

1. Display
2. JETS 1 key
3. JETS 2 key
4. Light key
5.
PRIMING MODE
Before examining in depth the minipool
user's interface, it is useful to remind
the procedure to follow when starting
complete emptying.
following indications in the installation
manual.
- Power the electric system up.
- Carry out an air exhaust procedure of
pipes and pumps.
power supply is cut off, the control panel
performs an inizialization procedure
starting in a safe and reliable way.
After inizialization, the control panel enters
a special working mode called "Priming
Mode" for a visual check of the proper
functioning.
DISPLAY FUNCTIONS - Model C
21
In this operating phase, the heater and
other minipool functions are disabled.
Make sure that water is dispensed from
jets after soon after. Switch on and off
repeatedly until the result is positive. Apply
the same function to the other pumps
visualised on display.
In case of failure to obtain an effective
functioning of the spa or an adequate
water circulaton, interrupt the activity, cut
power off and contact the technical
assistance service. Complete the exhaust
mode by means of the Exit key to bring
the control panel back to menu function.
In the event the spa is in "Priming Mode"
owing to a temporary power supply
failure, it was not emptied therefore it is
not necessary to purge the system, it is
possible to exit the screen through the
" " icon. In any case, after few minutes,
electronics is configurated to exit the
"Priming Mode" automatically.
EN