Alarm Codes; Rear Panel; Sockets Panel; Accessories - Selco Quasar 270 Instrucciones De Uso

3.2.2 Alarm codes

E99 General alarm
E01, E02 Temperature alarm
E10 Power module alarm
E19 System configuration alarm
E13 Communication alarm
E20 Memory fault alarm
E21 Data loss alarm
E23 Memory fault alarm (RC)
E24 Data loss alarm (RC)
E40 System power supply alarm

3.3 Rear panel

1 Power supply cable
Connects the system to the mains.
2 Signal cable (CAN-BUS) input (RC)
(Quasar 270 RC - Quasar 350 RC)
3 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.

3.4 Sockets panel

1 Negative power socket
For connection of earth cable in electrode welding or of
torch in TIG.
2 Positive power socket
For connection of electrode torch in MMA or earth
cable in TIG.

4 ACCESSORIES

4.1 General

Operation of the remote control is activated when connected
to the Selco power sources. This connection can be made also
with the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.

4.2 RC 100 remote control

The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".

4.3 RC 200 remote control

The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
"Consult the instruction manual".

4.4 RC 180 remote control

This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".
25