Descargar Imprimir esta página

Unpacking And Assembling - Mr. Heater Base Camp XCW20 Instrucciones De Funcionamiento Y Manual Del Propietario

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIFICATIONS
CAUTION: Certified for use only with LP-gas cylinders of the U.S. Department of Transportation (DOT) or Transport Canada,
CAN/CSA B339.
Model:
XCW20
(F235350)
10,000 -18,000
Rating: BTU
5.0Ah Sealed
Battery
Lead Acid Internal
Battery
Run Time (Full Charge)
40 minutes
Fuel Source
Propane
Fuel Supply Pressure
Max. Bottle
(to regulator):
Pressure
Gas Supply Pressure
11‰ WC
(Regulator out):
1 1 5V, 60 Hz, 1±, 2A
Electrical Input
Min. Operating
Voltage:100V
230 Watts (W)
FUSE 3AL 250V
High Temperature Control:
125°(F)
Temperature Rise
42°(F)
Electronic Spark
Ignition
DIMENSIONS
Model:
Length(in)
XCW20
19 1/2‰
(w/Handle Attached)

UNPACKING and ASSEMBLING

1.
Remove heater from carton.
2.
Remove all protective material which may have been applied
to the heater for shipment.
3.
Check the appliance for possible shipping damage and
straighten out all hoses to remove any kinks or twists. If any
damage is found immediately contact the manufacturer at
1-800-251-0001.
4.
Install handle assembly by screwing it into place.
5.
Attach the supplied regulator by rotating the t-wing nut in a
„clockwise‰ direction carefully not to over tighten.
6.
Attach the 1 LBS. LP cylinder to the regulator by rotating in a
„clockwise‰ direction. Only use LP cylinders with proper fuel
type approved for the appliance. Check for gas leaks with
soapy water.
DO NOT USE A FLAME TO CHECK FOR LEAKS.
Width(in)
Height(in)
Weight(LBS)
10 1/2‰
13‰
22 lbs.
3
Basecamp, Inc.| Portable Shower
Regulator
Assembly
Operating Instructions and OwnerÊs Manual
Handle Assembly
Pump Quick Connect Inlet Connection

Publicidad

loading