Descargar Imprimir esta página

Mr. Heater Base Camp XCW20 Instrucciones De Funcionamiento Y Manual Del Propietario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
Position the Output Temp Control Dial to the central position.
Depress the Pump button,the electronic ignition should be
heard igniting the burner. When the unit is ignited the Burner
icon on the control panel will illuminate and outlet water
temperature readout will increase. (FIG. 5)
6.
Take care to measure the temperature of the water from the
shower head, the temperature can be adjusted by turning the
„ Outlet Temperature Control Dial „ until the desired level is
reached.
7.
The water flow can be stopped at any time by sliding the
Switch to the „OFF‰ position (upwards). (FIG. 6) The burner
will extinguish and the pump will continue to operate for 5
minutes. To reignite the burner slide the Switch back to the
„OPEN‰ position (downwards), water will flow from shower
head and the burner will reignite within 5 to 10 seconds
OFF
FIG. 6
IMPORTANT – Water remaining in the heat exchanger while the
flow is stopped may become hot. When the flow is resumed the
user must check the temperature output to ensure that it is
suitable and not too hot. Test water temperature before bathing
children or pets.
8.
Once finished with the appliance slide the Switch to the
„OFF‰ position and depress the Pump button to stop the flow
of water to the appliance.
OPERATING FAUCET INSTRUCTIONS
1.
Press the power button and once the unit is ON depress the
Shower Head / Faucet button until the Faucet LED„Outlet‰
indicator lights on the LED control panel. (FIG. 7)
FIG. 7
FIG. 5
Switch
Basecamp, Inc.| Portable Shower
2.
Swing the faucet away from its storage position and locate
towards the side of the appliance and locate a basin or bucket
beneath and locate the water flow to the central position.
(FIG 8.)
3.
Position the „ Outlet Temperature Control Dial „in the Max posi-
tion then press the „Pump‰ button, water will start to flow within a
few moments.
4.
The electronic ignition should be heard igniting the burner,
when lit the „Burner‰ icon on the display will illuminate and
the outlet water temperature read out will increase. (FIG. 5)
5.
The water temperature can be adjusted by moving the „Output‰
Temp Control Dial knob between „Min & Max‰ or at the „Flow‰
valve at the Faucet. Turning the flow dial counterclockwise will
reduce the flow and cause the water temp to increase. Turning
the flow dial clockwise will increase the flow and cause the water
to decrease.
6.
The shower head hose can also be attached to the Faucet by con-
necting the quick connection from hose onto the Faucet outlet.
(FIG. 10)
5
Operating Instructions and OwnerÊs Manual
FIG. 8
(FIG. 9)
FIG. 9
Fig. 10

Publicidad

loading