Operation Of The Device; Lcd Display; Operation Information; Operating Instructions - Empi Phoenix Manual De Usuario

7.4 Operation of the Device

7.4.1 LCD display

The Empi Phoenix device is equipped with a Liquid Crystal Display (LCD) to make the User Interface easy to use and
understand, and to provide clear information about the on-going treatment. The following picture depicts the complete LCD
with all its symbols. Intensity Display, Intensity Bar Graph, and Open Circuit Icon are on the left for Channel 1 and on the right
for Channel 2.
Intensity Bar Graph

7.4.2 Operation information

• You can interrupt therapy at any time with the ON/OFF
• If the stimulator is not used, it switches off automatically after approximately 5 minutes.
• When the therapy timer is activated, the device switches off automatically at the end of the programmed interval. The
remaining therapy time is always indicated on the display.
• The program can only be changed when the intensity in both channels is 0.

7.4.3 Operating instructions

Turn on the device by pressing the ON/OFF
1.
The software version will be displayed briefly.
The LCD will then automatically switch to the Program Selection Screen.
2.
Use the Program Selection Increase
3.
program prescribed by your healthcare provider. Change of program is possible only
when both channel intensities are 0. The available programs are P1 (Disuse Atrophy), P2
(Reinforcement), P3 (TENS) and P4 (Edema). The list of programs is also mentioned on
the battery door label.
Phoenix User's Manual
Sequence
Indicator
Open Circuit Icon
Program Locked
button.
and Decrease
Low Battery Symbol
Work/Rest Symbol
Program/Sequence Timer
Intensity
Intensity Display
Locked Symbol
switch.
buttons to select the
21