Update Firmware - JMA MULTICODE SINGLE Manual De Instrucciones

10.6.1 ADJUST FLAT KEY JAW
In the jaw adjustment menus we select the jaw (S) we want to adjust. In this case, we select flat keys adjustment
(flat key).
Adjustment of the toothed jaw is very simple, take the tool CRG and place it in face 1 of the jaw we are going to use
(See Chapter 3.3.1 for placement of CRG in the jaw). In the menu we see, we can choose the jaw (M) we want, and
after selecting the jaw, we press the button to adjust the part of the cutter (F); the adjustment process is automatic.
NOTE: The settings area is very important, the cutter fp34, crg has no swarf.
If we adjust the MP1 jaw... it is convenient also to adjust the reader of the toothed keys on the cutter. After finishing
the adjustment of the cutter, remove the biting reader and without moving th CRG adjust the reader pressing the
adjustment button (L)

10.7 UPDATE FIRMWARE

The Firmware updating process is automatic, because when the program starts and connects to the MULTICODE SIN-
GLE it checks the version of the same and if it is not adequate it jumps to the updating window.
Access to this same window can be obtained through "JMAKeyPro" Adjustments and clicking on the part of updating.
NOTE: It is only recommendable to make the update when it jumps to a later or higher version of the software. It is
very important not to disconnect the machine until finishing the downloading process.
The updating process is very simple once we are in the following updating screen, we press ACCEPT and the process
starts automatically. The green diode of the machine will start to flash and will show us the following message:
86